Configure a Cellular Software Bypass Pair

Select
Workflows
Devices
Claimed Devices
, select the device you want to configure.
Select
Interfaces
.
Select a port.
For
Admin Up
, select
Yes
.
When you create a bypass pair, both the ports are up. When you bring down the bypass pair, both ports will be set to down. After that you have to bring up the ports individually. For security reasons, bringing up the individual port of the bypass pair is necessary. Failing to do so, the individual ports of the bypass pair will remain down and may impact the software upgrade process.
(Optional)
Enter a
Description
.
Select
Bypass Pair
as the
Interface Type
.
For
Pair With
, choose a pairing port to create a bypass pair and then click
Done
.
Set one port as WAN and the second as LAN on the
Couple Ports to create a Bypass Pair
pop-up. For cellular bypass pairs, the cellular interface is always WAN and the peer is always LAN.

For
Use These Ports For
, select either
Internet
, or
Private WAN
.
Choose a
Circuit Label
.
The circuit label for the cellular interface should match the circuit label for the peer device’s directly attached cellular interface.
The
IPv4 Configuration
is auto-negotiated for the Cellular bypass.
Configure the Cellular WAN interface as an internet transit zone in the
NAT Zone
configuration.
Save
the bypass pair.