Enable Authentication Using a Certificate Profile

Configure an IPSec tunnel for the GlobalProtect gateway for communicating with a strongSwan client.
Select
Network
GlobalProtect
Gateways
and then select the gateway name.
Select the
Certificate Profile
you want to use for authentication in the
Authentication
tab.
Select
Agent
Tunnel Settings
and specify the following settings to set up a tunnel:
Select the check box to
Enable X-Auth Support
.
If a
Group Name
and
Group Password
are already configured, remove them.
Click
OK
to save the settings.
Verify that the default connection settings in the conn %default section of the IPSec tunnel configuration file (ipsec.conf) are correctly defined for the strongSwan client.
The ipsec.conf file is usually found in the /etc folder.
The configurations in this procedure are tested and verified for the following releases:
Ubuntu 14.0.4 with strongSwan 5.1.2 and CentOS 6.5 with strongSwan 5.1.3 for PAN-OS 6.1.
Ubuntu 14.0.4 with strongSwan 5.2.1 for PAN-OS 7.0.
The configurations in this procedure can be used for reference if you are using a different version of strongSwan. Refer to the strongSwan wiki for more information.
In the conn %default section of the ipsec.conf file, configure the following recommended settings.
ikelifetime=
20m 
reauth=
yes 
rekey=
yes 
keylife=
10m 
rekeymargin=
3m 
rekeyfuzz=
0% 
keyingtries=
1 
type=
tunnel 
Modify the strongSwan client’s IPSec configuration file (ipsec.conf) and the IPSec password file (ipsec.secrets) to use recommended settings.
The ipsec.secrets file is usually found in the /etc folder.
Use the strongSwan client username as the certificate’s common name.
Configure the following recommended settings in the ipsec.conf file:
conn <
connection name> 
keyexchange=
ikev1 
authby=
rsasig 
ike=
aes-sha1-modp1024,aes256 
left=<
strongSwan/Linux-client-IP-address> 
leftcert=<
client certificate with the strongSwan client username
used as the certificate’s common name> 
leftsourceip=
%config 
leftauth2=
xauth 
right=<
GlobalProtect-gateway-IP-address> 
rightid=“
CN=<Subject-name-of-gateway-cert>” 
rightsubnet=
0.0.0.0/0 
auto=
add 
Configure the following recommended settings in the ipsec.secrets file:
:RSA <
private key file> “<
passphrase if used>”
Start strongSwan IPSec services and connect to the IPSec tunnel that you want the strongSwan client to use when authenticating to the GlobalProtect gateway.
Use the
config <name>
variable to name the tunnel configuration.
Ubuntu clients:
ipsec start  
ipsec up <
name> 
CentOS clients:
strongSwan start 
strongswan up <
name> 
Verify that the tunnel is set up correctly and the VPN connection is established to both the strongSwan client and the GlobalProtect gateway.
Verify the detailed status information on a specific connection (by naming the connection) or verify the status information for all connections from the strongSwan client:
Ubuntu clients:
ipsec statusall [<
connection name>]
CentOS clients:
strongswan statusall [<
connection name>]
Select
Network
GlobalProtect
Gateways
. Then, in the Info column, select
Remote Users
for the gateway configured for the connection to the strongSwan client. The strongSwan client should be listed under
Current Users
.