Install an ION 1200 in an equipment rack using mounting
brackets and rails.
Mount the ION device in a 19” equipment rack
using the racktray. The mounting equipment requires 1 RU of rack
Maintain a minimum of 7.5" height clearance for
the antennas in the rack.
Slide one of the adjustable mounting brackets
into one of the fixed mounting brackets to create a mounting rail.
Repeat for the second mounting rail. The adjustable and fixed brackets
are the same for the left and right side.
Align the bottom edge of the mounting rails to the bottom
of the 1 RU rack space reserved for the device. Align the slotted
holes in the adjustable mounting bracket to the holes on the rear
of the equipment frame.
The mounting rails are designed for equipment frames
that are 26” to 32” deep.
Secure the rails to the equipment frame with mounting
screws (not provided) compatible with your equipment frame. Tighten
the screws to their recommended torque value.
With the front of the device facing forward, align the
four rubber feet on the bottom of the device to the slotted holes
in the provided mounting tray.
Secure the device in place using three of the provided
#6-32 x 3/16” Long Flathead screws.
Slide the device power supply into the marked position
and fasten the provided velcro strap around the power supply until
it is secure in place.
Plug the power supply connector into the back of the
device. Using the provided tie-wraps, bind and secure the power
supply cable to the metal hooks in the mounting tray.
Slide the mounting tray into the rails previously fixed
to the equipment rack. Stop when the front flange on the mounting
tray is flush with the front of the rail.
Align the slotted holes in the mounting tray to the holes
in the equipment frame. Secure the mounting tray to the equipment
frame on both sides using 3 screws each (not provided). The screws
must be compatible with your equipment frame.