Share User-ID Mappings Across Virtual Systems
To share IP address-to-username mappings across virtual systems, assign a virtual system as a User-ID hub.
To simplify User-ID™ source configuration when you have multiple virtual systems, configure the User-ID sources on a single virtual system to share IP address-to-username mappings with all other virtual systems on the firewall.
Configuring a single virtual system as a User-ID hub simplifies user mapping by eliminating the need to configure the sources on multiple virtual systems, especially if a user’s traffic will pass through multiple virtual systems based on the resources the user is trying to access (for example, in an academic networking environment where a student will be accessing different departments whose traffic is managed by different virtual systems).
To map the user, the firewall uses the mapping table on the local virtual system and applies the policy for that user. If the firewall does not find the mapping for a user on the virtual system where that user’s traffic originated, the firewall queries the hub to fetch the IP address-to-username information for that user. If the firewall locates the mapping on both the User-ID hub and the local virtual system, the firewall uses the mapping it learns locally.
After you configure the User-ID hub, the virtual system can use the mapping table on the User-ID hub when it needs to identify a user for user-based policy enforcement or to display the username in a log or report but the source is not available locally. When you select a hub, the firewall retains the mappings on other virtual systems so we recommend consolidating the User-ID sources on the hub. However, if you don’t want to share mappings from a specific source, you can configure an individual virtual system to perform user mapping.
- Assign the virtual system as a User-ID hub.
- Selectand then select the virtual system where you consolidated your User-ID sources.DeviceVirtual Systems
- On theResourcetab,Make this vsys a User-ID data huband clickYesto confirm. Then clickOK.
- Consolidate your User-ID sources and migrate them to the virtual system that you want to use as a User-ID hub.This consolidates the User-ID configuration for operational simplicity. By configuring the hub to monitor servers and connect to agents that were previously monitored by other virtual systems, the hub collects the user mapping information instead of having each virtual system collect it independently. If you don’t want to share mappings from specific virtual systems, configure those mappings on a virtual system that will not be used as the hub.
- Remove any sources that are unnecessary or outdated.
- On the hub, you can configure any User-ID source that is currently configured on a virtual system. However, IP address-and-port-to-username mapping information from Terminal Server agents and group mappings are not shared between the User-ID hub and the connected virtual systems.
- Specify the subnetworks that User-ID should include in or exclude from mapping.
- Define theIgnore User List.
- On all other virtual systems, remove any sources that are on the User-ID hub.
- Committhe changes to enable the User-ID hub and begin collecting mappings for the consolidated sources.
- Confirm the User-ID hub is mapping the users.
- Use theshow user ip-user-mapping allcommand to show the IP address-to-username mappings and which virtual system provides the mappings.
- Use theshow user user-id-agent statisticscommand to show which virtual system is serving as the User-ID hub.
Recommended For You
Recommended videos not found.