1. Home
    2. PAN-OS
    3. PAN-OS Web Interface Help
    4. Network
    5. Network > Interfaces
    6. Log Card Interface

    Log Card Interface

    • Network > Interfaces > Ethernet
    If you configure log forwarding on a PA-7000 Series firewall with a Log Processing Card (LPC), you must configure one data port as type
    Log Card
    . This is because the traffic and logging capabilities of this firewall model exceed the capabilities of the management (MGT) interface. A log card data port performs log forwarding for syslog, email, Simple Network Management Protocol (SNMP), Panorama log forwarding, and WildFire™ file-forwarding.
    You can configure only one port on the firewall as type
    Log Card
    . If you enable log forwarding but do not configure an interface with the
    Log Card
     type, you get an error when you attempt to commit your changes.
    This information pertains to configuring a Log Processing Card (LPC). To learn how to configure a Log Forwarding Card (LFC), see Device > Log Forwarding Card
    To configure a log card interface, select an Interface that is not configured (ethernet1/16, for example) and configure the settings described in the following table.
    Log Card Interface Settings
    Configured In
    Description
    Slot
    Ethernet Interface
    Select the slot number (1-12) of the interface.
    Interface Name
    The interface name is predefined and you cannot change it.
    Comment
    Enter an optional description for the interface.
    Interface Type
    Select
    Log Card
    .
    IPv4
    Ethernet Interface
    Log Card Forwarding
    If your network uses IPv4, define the following:
    • IP address
      —The IPv4 address of the port.
    • Netmask
      —The network mask for the IPv4 address of the port.
    • Default Gateway
      —The IPv4 address of the default gateway for the port.
    IPv6
    If your network uses IPv6, define the following:
    • IP address
      —The IPv6 address of the port.
    • Default Gateway
      —The IPv6 address of the default gateway for the port.
    Link Speed
    Ethernet Interface
    Advanced
    Select the interface speed in Mbps (
    10
    ,
    100
    , or
    1000
    ) or select
    auto
     (default) to have the firewall automatically determine the speed based on the connection. For interfaces that have a non-configurable speed,
    auto
     is the only option.
    The minimum recommended speed for the connection is
    1000
     (Mbps).
    Link Duplex
    Select whether the interface transmission mode is full-duplex (
    full
    ), half-duplex (
    half
    ), or negotiated automatically based on the connection (
    auto
    ). The default is
    auto
    .
    Link State
    Select whether the interface status is enabled (
    up
    ), disabled (
    down
    ), or determined automatically based on the connection (
    auto
    ). The default is
    auto
    .

    Recommended For You

    Recommended Videos

    Recommended videos not found.

    © 2022 Palo Alto Networks, Inc. All rights reserved.

    Techdocs Logo