: Log Collector RAID Disk Settings
Focus
Focus

Log Collector RAID Disk Settings

Table of Contents

Log Collector RAID Disk Settings

  • Panorama > Managed Collectors > Disks
After you configure logging disks on the M-Series appliance or Panorama virtual appliance, you can Add them to the Log Collector configuration.
By default, M-Series appliances are shipped with the first RAID 1 disk pair installed in bays A1 and A2. In the software, the disk pair in bays A1 and A2 is named Disk Pair A. The remaining bays are named sequentially: Disk Pair B, Disk Pair C, and so on. For example, the M-500 appliance supports up to 12 disk pairs. You can install pairs of 2TB or 1TB disks within the same appliance; however, disk size must be the same for both drives within each pair.
The Panorama virtual appliance supports up to 12 virtual logging disks for 24TB of storage capacity.
After you add disk pairs, the Log Collector redistributes its existing logs across all the disks, which can take hours for each terabyte of logs. During the redistribution process, the maximum log ingestion rate is reduced. In the PanoramaManaged Collectors page, the Log Redistribution State column indicates the completion status of the process as a percentage.
If you use an SNMP manager for centralized monitoring, you can see loggings statistics in the panLogCollector MIB.