An enhancement was made to enable you to
configure syslog parameters through the CLI debug command. To view
the available parameters and change the configurations, run the
debug syslogng-params settings
command and perform a commit force to apply the edits.
Fixed an issue where the dataplane restarted
due to a callback function, which caused a deadlock condition.
Fixed an issue where Wildfire® signature
version information was no longer displayed after you activated
a GlobalProtect client.
Fixed a rare issue on a firewall in a high
availability (HA) active/passive configuration running in FIPS-CC
mode where the passive firewall rebooted in to maintenance mode.
Fixed an issue where a process (
ran out of file descriptors and stopped responding due to the rate
of concurrent Security Assertion Markup Language (SAML) requests
initiated by Authentication policy rules.
Fixed an issue where the
show config audit base-version
command continuously increased the number of file descriptors and
caused a process (
) to exit and restart.
PA-7000 Series firewalls only
Fixed an issue where the Quad Small Form-factor Pluggable (QSFP)
port on a 20GQ NPC card unexpectedly entered low power mode and
did not link up.
Fixed an issue where the dataplane did not
receive enough keep-alive packets as expected, which caused the
Syslog server connection to age-out.
Fixed an issue where a PA-5200 Series firewall
processed traffic that was in suspended mode.
Fixed an issue where deleting all FQDN objects
that are no longer in use did not remove them from the FQDN refresh
table, which caused firewalls to continue resolving these old objects
per the schedule.