IPSec Tunnel Proxy IDs Tab
- Network > IPSec Tunnels > Proxy IDs
IPSec Tunnel Proxy IDstab is separated into two tabs:
IPv6. The help is similar for both types; the differences between IPv4 and IPv6 are described in the
Remotefields in the following table.
IPSec Tunnel Proxy IDstab is also used for specifying traffic selectors for IKEv2.
Proxy IDs IPv4 and IPv6 Settings
Addand enter a name to identify the proxy.
For an IKEv2 traffic selector, this field is used as the Name.
For IPv4: Enter an IP address or subnet in the format x.x.x.x/mask (for example, 10.1.2.0/24).
For IPv6: Enter an IP address and prefix length in the format xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx/prefix-length (or per IPv6 convention, for example, 2001:DB8:0::/48).
IPv6 addressing does not require that all zeros be written; leading zeros can be omitted and one grouping of consecutive zeros can be replaced by two adjacent colons (::).
For an IKEv2 traffic selector, this field is converted to Source IP Address.
If required by the peer:
For IPv4, enter an IP address or subnet in the format x.x.x.x/mask (for example, 10.1.1.0/24).
For IPv6, enter an IP address and prefix length in the format xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx/prefix-length (or per IPv6 convention, for example, 2001:DB8:55::/48).
For an IKEv2 traffic selector, this field is converted to Destination IP Address.
Specify the protocol and port numbers for the local and remote ports:
Number—Specify the protocol number (used for interoperability with third-party devices).
Each configured proxy ID will count towards the IPSec VPN tunnel capacity of the firewall.
This field is also used as an IKEv2 traffic selector.
Configure IKEv2 Traffic Selectors
Configure IKEv2 Traffic Selectors In IKEv2, you can configure Traffic Selectors , which are components of network traffic that are used during IKE negotiation. Traffic ...
Set Up an IPSec Tunnel
Set Up an IPSec Tunnel The IPSec tunnel configuration allows you to authenticate and/or encrypt the data (IP packet) as it traverses across the tunnel. ...
Traffic Selectors In IKEv1, a firewall that has a route-based VPN needs to use a local and remote Proxy ID in order to set up ...
Tunnel Interface To set up a VPN tunnel, the Layer 3 interface at each end must have a logical tunnel interface for the firewall to ...
Network > IPSec Tunnels
Network > IPSec Tunnels Select Network IPSec Tunnels to establish and manage IPSec VPN tunnels between firewalls. This is the Phase 2 portion of the ...
IPSec Tunnel General Tab
IPSec Tunnel General Tab Network > IPSec Tunnels > General Use the following fields to set up an IPSec tunnel. IPSec Tunnel General Settings Description ...
Create an NPTv6 Policy
Create an NPTv6 Policy Perform this task when you want to configure a NAT NPTv6 policy to translate one IPv6 prefix to another IPv6 prefix. ...
Set Up an IKE Gateway
Set Up an IKE Gateway To set up a VPN tunnel, the VPN peers or gateways must authenticate each other—using pre-shared keys or digital certificates—and ...
DNS Proxy Overview
DNS Proxy Overview You can configure the firewall to act as a DNS server. First, create a DNS proxy and select the interfaces to which ...