Device > Setup > Interfaces
Use this page to configure connection settings, allowed services, and administrative access for the management (MGT) interface on all firewall models and for the auxiliary interfaces (AUX-1 and AUX-2) on PA-5200 Series firewalls.
Palo Alto Networks recommends that you always specify the IP address and netmask (for IPv4) or prefix length (for IPv6) and the default gateway for every interface. If you omit any of these settings for the MGT interface (such as the default gateway), you can access the firewall only through the console port for future configuration changes.
MGT interface only)
If you select
DHCP Client, optionally click
Show DHCP Client Runtime Infoto view the dynamic IP interface status:
Optionally, you can
Renewthe DHCP lease for the IP address assigned to the MGT interface. Otherwise,
Aux 1 / Aux 2
PA-5200 Series firewalls only)
Select any of the following options to enable an auxiliary interface. These interfaces provide 10Gbps (SFP+) throughput for:
Enable HTTPS instead of HTTP for the web interface and enable SSH instead of Telnet for the CLI.
IP Address (IPv4)
If your network uses IPv4, assign an IPv4 address to the interface. Alternatively, you can assign the IP address of a loopback interface for firewall management (see Network > Interfaces > Loopback). By default, the IP address you enter is the source address for log forwarding.
If you assigned an IPv4 address to the interface, you must also enter a network mask (for example, 255.255.255.0).
If you assigned an IPv4 address to the interface, you must also assign an IPv4 address to the default gateway (the gateway must be on the same subnet as the interface).
IPv6 Address/Prefix Length
If your network uses IPv6, assign an IPv6 address to the interface. To indicate the netmask, enter an IPv6 prefix length (for example, 2001:db8:300::1/64).
Default IPv6 Gateway
If you assigned an IPv6 address to the interface, you must also assign an IPv6 address to the default gateway (the gateway must be on the same subnet as the interface); for example, 2001:db8:300::5.
Configure a data rate and duplex option for the interface. The choices include 10Mbps, 100Mbps, and 1Gbps at full or half duplex. Use the default auto-negotiate setting to have the firewall determine the interface speed.
This setting must match the port settings on the neighboring network equipment. To ensure matching settings, select auto-negotiate if the neighboring equipment supports that option.
Enter the maximum transmission unit (MTU) in bytes for packets sent on this interface (range is 576 to 1,500; default is 1,500).
Administrative Management Services
Select the services you want to enable on the interface:
Permitted IP Addresses
Enter the IP addresses from which administrators can access the firewall through the interface. An empty list (default) specifies that access is available from any IP address.
Do not leave the list blank; specify only the IP addresses of firewall administrators to prevent unauthorized access.
Recommended For You
Recommended videos not found.