The following table describes the virtual router’s Runtime Stats for RIP.
RIP Runtime Stats
Number of seconds in an interval. RIP uses this value (a length of time) to control its Update, Expire, and Delete Intervals.
Number of intervals between RIP route advertisement updates that the virtual router sends to peers.
Number of intervals since the last update the virtual router received from a peer, after which the virtual router marks the routes from the peer as unusable.
Number of intervals after a route has been marked as unusable that, if no update is received, the firewall deletes the route from the routing table.
IP address of an interface on the virtual router where RIP is enabled.
Type of authentication: simple password, MD5, or none.
Check mark indicates this interface is allowed to send RIP packets.
Check mark indicates this interface is allowed to receive RIP packets.
Advertise Default Route
Check mark indicates that RIP will advertise its default route to its peers.
Default Route Metric
Metric (hop count) assigned to the default route. The lower the metric value, the higher priority it has in the route table to be selected as the preferred path.
Authentication key used with peers.
Preferred key for authentication.
IP address of a peer to the virtual router’s RIP interface.
Date and time that the last update was received from this peer.
RIP version the peer is running.
Count of invalid packets received from this peer. Possible causes that the firewall cannot parse the RIP packet: x bytes over a route boundary, too many routes in packet, bad subnet, illegal address, authentication failed, or not enough memory.
Count of invalid routes received from this peer. Possible causes: route is invalid, import fails, or not enough memory.
RIP Routing Information Protocol (RIP) is an interior gateway protocol (IGP) that was designed for small IP networks. RIP relies on hop count to determine ...
RIP Timers Tab
RIP Timers Tab Network > Virtual Router > RIP > Timers The following table describes the timers that control RIP route updates and expirations. RIP ...
RIP Interfaces Tab
RIP Interfaces Tab Network > Virtual Routers > RIP > Interfaces Use the following fields to configure RIP interfaces: RIP – Interface Settings Description Interface ...
Configure BGP Perform the following task to configure BGP. Configure general virtual router configuration settings. See Virtual Routers for details. Enable BGP for the virtual ...
BGP Tab The following table describes the virtual router’s Runtime Stats for BGP. BGP Runtime Stats Description Summary Tab Router Id Router ID assigned to ...
RIP Export Rules Tab
RIP Export Rules Tab Network > Virtual Router > RIP > Export Rules RIP export rules allow you to control which routes the virtual router ...
RIP Network > Virtual Routers > RIP Configuring the Routing Information Protocol (RIP) includes the following general settings: RIP Settings Description Enable Select to enable ...
BGP Conditional Adv Tab
BGP Conditional Adv Tab Network > Virtual Router > BGP > Conditional Adv A BGP conditional advertisement allows you to control which route to advertise ...
Routing Tab The following table describes the virtual router’s runtime stats for the Route Table , Forwarding Table , and the Static Route Monitoring table. ...