- Network > Virtual Router > OSPF
Configuring the Open Shortest Path First (OSPF) protocol requires you to configure the following general settings (except BFD, which is optional):
Select to enable the OSPF protocol.
Reject Default Route
(Recommended) Select if you do not want to learn any default routes through OSPF.
Specify the router ID associated with the OSPF instance in this virtual router. The OSPF protocol uses the router ID to uniquely identify the OSPF instance.
To enable Bidirectional Forwarding Detection (BFD) for OSPF globally for the virtual router on a PA-3000 Series, PA-5200 Series, PA-7000 Series, or VM-Series firewall, select one of the following:
Select None (Disable BFD) to disable BFD for all OSPF interfaces on the virtual router; you cannot enable BFD for a single OSPF interface.
In addition, you must configure OSPF settings on the following tabs:
OSPFv3 Network > Virtual Router > OSPFv3 Configuring the Open Shortest Path First v3 (OSPFv3) protocol requires configuring the first three settings in the following ...
Configure BFD After you read the BFD Overview , which includes firewall models and interfaces supported, perform the following before configuring BFD: Configure one or ...
Configure OSPF OSPF determines routes dynamically by obtaining information from other routers and advertising routes to other routers by way of Link State Advertisements (LSAs). ...
RIP Network > Virtual Routers > RIP Configuring the Routing Information Protocol (RIP) includes the following general settings: RIP Settings Description Enable Select to enable ...
OSPF Areas Tab
OSPF Areas Tab Network > Virtual Router > OSPF > Areas The following fields describe the OSPF area settings: OSPF – Areas Settings Description Areas ...
Configure OSPFv3 OSPF supports both IPv4 and IPv6. You must use OSPFv3 if you are using IPv6. Configure general virtual router configuration settings. See Virtual ...
OSPFv3 Areas Tab
OSPFv3 Areas Tab Network > Virtual Router > OSPFv3 > Areas Use the following fields to configure OSPFv3 areas. OSPv3 – Areas Settings Description Authentication ...
BFD for Dynamic Routing Protocols
BFD for Dynamic Routing Protocols In addition to BFD for static routes, the firewall supports BFD for the BGP, OSPF, and RIP routing protocols. The ...
Site-to-Site VPN with Static and Dynamic Routing
Site-to-Site VPN with Static and Dynamic Routing In this example, one site uses static routes and the other site uses OSPF. When the routing protocol ...