RIP Timers Tab
- Network > Virtual Router > RIP > Timers
The following table describes the timers that control RIP route updates and expirations.
RIP – Timer Settings
Interval Seconds (sec)
Define the length of the timer interval in seconds. This duration is used for the remaining RIP timing fields (range is 1-60).
Enter the number of intervals between route update announcements (range is 1-3,600).
Enter the number of intervals between the time that the route was last updated to its expiration (range is 1-3,600).
Enter the number of intervals between the time that the route expires to its deletion (range is 1-3,600).
RIP Routing Information Protocol (RIP) is an interior gateway protocol (IGP) that was designed for small IP networks. RIP relies on hop count to determine ...
RIP Tab The following table describes the virtual router’s Runtime Stats for RIP. RIP Runtime Stats Description Summary Tab Interval Seconds Number of seconds in ...
OSPFv3 Advanced Tab
OSPFv3 Advanced Tab Network > Virtual Router > OSPFv3 > Advanced Use the following fields to disable transit routing for SPF calculations, configure OSPFv3 timers, ...
PA-7000 Series Layer 3 Interface
PA-7000 Series Layer 3 Interface Network > Interfaces > Ethernet To configure a Layer 3 interface, select an interface (ethernet1/1, for example) and specify the ...
RIP Network > Virtual Routers > RIP Configuring the Routing Information Protocol (RIP) includes the following general settings: RIP Settings Description Enable Select to enable ...
HA Timers High availability (HA) timers facilitate a firewall to detect a firewall failure and trigger a failover. To reduce the complexity in configuring HA ...
OSPF Advanced Tab
OSPF Advanced Tab Network > Virtual Router > OSPF > Advanced The following fields describe RFC 1583 compatibility, OSPF timers, and graceful restart: OSPF – ...
Network > Interfaces > VLAN
Network > Interfaces > VLAN A VLAN interface can provide routing into a Layer 3 network (IPv4 and IPv6). You can add one or more ...