Reverse-Path Forwarding
Focus
Focus

Reverse-Path Forwarding

Table of Contents
End-of-Life (EoL)

Reverse-Path Forwarding

PIM uses reverse-path forwarding (RPF) to prevent routing loops and to build a shortest-path tree from the receiver back to the multicast source.
PIM uses reverse-path forwarding (RPF) to prevent multicast routing loops by leveraging the unicast routing table on the virtual router. When the virtual router receives a multicast packet, it looks up the source of the multicast packet in its unicast routing table to see if the outgoing interface associated with that source IP address is the interface on which that packet arrived. If the interfaces match, the virtual router duplicates the packet and forwards it out the interfaces toward the multicast receivers in the group. If the interfaces don’t match, the virtual router drops the packet. The unicast routing table is based on the underlying static routes or the interior gateway protocol (IGP) your network uses, such as OSPF.
PIM also uses RPF to build a shortest-path tree to a source, one PIM router hop at a time. The virtual router has the address of the multicast source, so the virtual router selects as its next hop back to the source the upstream PIM neighbor that the virtual router would use to forward unicast packets to the source. The next hop router does the same thing.
After RPF succeeds and the virtual router has a route entry in its multicast routing information base (mRIB), the virtual router maintains source-based tree entries (S,G) and shared tree entries (*,G) in its multicast forwarding information base (multicast forwarding table or mFIB). Each entry includes the source IP address, multicast group, incoming interface (RPF interface) and outgoing interface list. There can be multiple outgoing interfaces for an entry because the shortest path tree can branch at the router, and the router must forward the packet out multiple interfaces to reach receivers of the group that are located down different paths. When the virtual router uses the mFIB to forward a multicast packet, it matches an (S,G) entry before it attempts to match a (*,G) entry.
If you are advertising multicast source prefixes into BGP (you configured MP-BGP with the IPv4 Address Family and the multicast Subsequent Address Family), then the firewall always performs the RPF check on the BGP routes that the firewall received under the multicast Subsequent Address Family.
View IP Multicast Information to see how to view the mFIB and mRIB entries. Keep in mind that the multicast route table (mRIB) is a separate table from the unicast route table (RIB).