Set Up HA on Panorama
- Set up connectivity between the MGT ports on the HA peers.The Panorama peers communicate with each other using the MGT port. Make sure that the IP addresses you assign to the MGT port on the Panorama servers in the HA pair are routable and that the peers can communicate with each other across your network. To set up the MGT port, see Perform Initial Configuration of the Panorama Virtual Appliance or Perform Initial Configuration of the M-Series Appliance.Pick a Panorama peer in the pair and complete the remaining tasks.
- Enable HA and (optionally) enable encryption for the HA connection.
- Selectand edit thePanoramaHigh AvailabilitySetupsection.
- SelectEnable HA.
- In thePeer HA IP Addressfield, enter the IP address assigned to the peer Panorama.
- In theMonitor Hold Timefield, enter the length of time (milliseconds) that the system will wait before acting on a control link failure (range is 1000-60000, default is 3000).
- If you do not want encryption, clear theEncryption Enabledcheck box and clickOK: no more steps are required. If you do want encryption, select theEncryption Enabledcheck box, clickOK, and perform the following tasks:
- Select.PanoramaCertificate ManagementCertificates
- SelectExport HA key. Save the HA key to a network location that the peer Panorama can access.
- On the peer Panorama, navigate to, selectPanoramaCertificate ManagementCertificatesImport HA key, browse to the location where you saved the key, and import it.
- Set the HA priority.
- In, edit thePanoramaHigh AvailabilityElection Settingssection.
- Define theDevice PriorityasPrimaryorSecondary. Make sure to set one peer as primary and the other as secondary.If both peers have the same priority setting, the peer with the higher serial number will be placed in a suspended state.
- Define thePreemptivebehavior. By default preemption is enabled. The preemption selection—enabled or disabled—must be the same on both peers.
- To configure path monitoring, define one or more path groups.The path group lists the destination IP addresses (nodes) that Panorama must ping to verify network connectivity.Perform the following steps for each path group that includes the nodes that you want to monitor.
- Selectand, in the Path Group section, clickPanoramaHigh AvailabilityAdd.
- Enter aNamefor the path group.
- Select aFailure Conditionfor this group:
- anytriggers a path monitoring failure if any one of the IP addresses becomes unreachable.
- alltriggers a path monitoring failure only when none of the IP addresses are reachable.
- Addeach destination IP address you want to monitor.
- ClickOK. The Path Group section displays the new group.
- (Optional) Select the failure condition for path monitoring on Panorama.
- Selectand edit the Path Monitoring section.PanoramaHigh Availability
- Select aFailure Condition:
- alltriggers a failover only when all monitored path groups fail.
- anytriggers a failover when any monitored path group fails.
- Commit your configuration changes.SelectandCommitCommit to PanoramaCommityour changes.
- Synchronize the Panorama peers.
- Access theDashboardon the active Panorama and selectto display the HA widget.WidgetsSystemHigh Availability
- Sync to peer, clickYes, and wait for theRunning Configto displaySynchronized.
- Access theDashboardon the passive Panorama and selectto display the HA widget.WidgetsSystemHigh Availability
- Verify that theRunning ConfigdisplaysSynchronized.
Recommended For You
Recommended videos not found.