Troubleshoot Policy Rule Traffic Match
Test the traffic policy match of the running firewall
configuration.
To perform policy match tests for managed
firewalls, test the policy rule configuration for your managed devices
to ensure that the running configuration appropriately secures your
network by allowing and denying the correct traffic. After the results
are generated for traffic that was matched to configured rules,
you can
Export to PDF
for auditing purposes.- Select to perform a policy match.You may also run a policy match test from thePoliciestab.
- Enter the required information to perform the policy match test. In this example, a Security policy match test is run.
- SelectSecurity Policy Matchfrom theSelect Testdrop-down.
- Select device/VSYSand select the managed firewalls to test.
- Enter the Source IP address from which traffic originated.
- Enter the Destination IP address of the target device for the traffic.
- Enter the Protocol IP used for the traffic.
- If necessary, enter any additional information relevant for your Security policy rule testing.
- Executethe Security policy match test.
- Select the Security policy match Results to review the policy rules that match the test criteria.
