Known Issues in Panorama Plugin for VMware NSX 3.1.0
The following list describes known issues
in the Panorama plugin for VMware NSX 3.1.0.
You can open the NSX Manager Objects
displays no information.
The connection between NSX-T Manager
and Panorama goes
Out of Sync
if you change
the NSX-T Manager IP address configured on Panorama.
: To change the NSX-T Manager IP address, you
must completely reconfigure and reinstall your VM-Series firewall
on NSX-T deployment. If there are active firewall in your deployment,
you must remove those before deleting the service manager. You must
delete the Service Manager configuration from Panorama and add it again
with the new IP address. To delete the Service Manager, you must
remove the rest of your VM-Series on NSX-T configuration from Panorama.
When a device group is added or removed
from an existing notify group, existing dynamic address groups are
not updated to reflect the device group change.
Workaround: Synchronize Dynamic Objects on
to update dynamic address groups.
In a Panorama HA pair, NSX-T plugin configuration
is not automatically synchronized to the passive Panorama if the
passive Panorama comes up after the active Panorama.
: On the Panorama dashboard, Synchronize to
Peer on the HA widget.
After a Panorama failover event, if there
are some configuration objects in NSX-T Manager but not Panorama,
you must manually remove those objects from NSX-T Manager.
: Contact VMware for information about manually
removing the objects from NSX-T Manager.
Panorama incorrectly allows the modification
of the NSX-T plugin configuration while in a suspended state. Do
not attempt to modify the NSX-T plugin configuration on a suspended
Panorama; this action is not supported.