Prisma Access
Enable IPv6 Networking for Service Connections (Strata Cloud Manager)
Table of Contents
Expand All
|
Collapse All
Prisma Access Docs
-
- Prisma Access China
- 4.0 & Later
- 3.2 Preferred and Innovation
- 3.1 Preferred and Innovation
- 3.0 Preferred and Innovation
- 2.2 Preferred
-
-
-
- 5.2 Preferred and Innovation
- 5.1 Preferred and Innovation
- 5.0 Preferred and Innovation
- 4.2 Preferred
- 4.1 Preferred
- 4.0 Preferred
- 3.2 Preferred and Innovation
- 3.1 Preferred and Innovation
- 3.0 Preferred and Innovation
- 2.2 Preferred
Enable IPv6 Networking for Service Connections (Strata Cloud Manager)
- Select ManageService ConnectionsService Connections Setup.If you're using Strata Cloud Manager, go to WorkflowsPrisma Access SetupService Connectionsand Add Service Connection.Add a new service connection or select an existing service connection to edit it.Set up IPv6 routing for the service connection.
- (Static Routing Deployments Only) Enter one or more Corporate Subnets in the Static Routes tab.(BGP Routing Deployments Only) Specify the method to exchange IPv4 and IPv6 BGP routes; then, enter an IPv6 Peer Address and Local Address.
- To use a single IPv4 BGP session to exchange both IPv4 and IPv6 BGP peering information, select Exchange both IPv4 and IPv6 routes over IPv4 peering.
- To an IPv4 BGP session to exchange IPv4 BGP peering information and an IPv6 session to exchange IPv6 BGP peering information, select Exchange IPv4 routes over IPv4 peering and IPv6 routes over IPv6 peering.
- To use a single IPv6 BGP session to exchange IPv6 BGP peering information, select Exchange IPv6 routes over IPv6 peering.
If your secondary WAN uses a different peer or local address, deselect Same as Primary WAN and enter the IPv6 Peer Address and Local Address for the secondary WAN.If you have not yet completed the your service connection setup, complete it now. See Configure a Service Connection in for details.IPv6 internet access for service connections is enabled by an underlay connection, in which IPv6 traffic is passed through an IPv4 tunnel.Push Config to deploy your changes to you network.If you have not yet completed the mobile users configuration, complete it now.