The Time Range Selection Filter

The data displayed in most of the widgets is filtered based on the
Time Range
selected.
The time is localized, so you will be able to filter based on the local time for your region. Data is fetched every minute but datapoints shown in most histograms vary according to the
Time Range
selected.
For your convenience, Prisma Access Insights lets you pick the
Time Range
from a few pre-defined ranges or configure your own date and time range too:
  • Last 15 min
    1 datapoint for every 1 minute or 3 minutes depending on the widget.
  • Last 1 Hour
    1 datapoint for every 1 minute or 3 minutes depending on the widget.
  • Last 24 Hours
    1 datapoint for every single hour for a total of 24 datapoints.
  • Last 7 Days
    1 datapoint for every single day for a total of 7 datapoints
  • Last 30 Days
    1 datapoint for every single day for a total of 30 datapoints.
  • Custom
    You can set a custom time interval (date and the time, for example start at 5:00 pm on June 1 and end at 4:00 pm on June 2) in addition to the pre- populated
    Time Range
    selections available in the filter. The allowed custom time range interval is a minimum of 1 minute and a maximum of now minus 30 days.
    To set a start time, first select the date in the calendar, then select the time under
    Start
    .
    Apply
    the start time, then set the end time by selecting an end date in the calendar and then a time under
    End
    .
    Once you set a custom time range, it gets saved and applied across all widgets within Insights that use the time range filter to display data instead of real time data.

Recommended For You