Onboard a Non-ECMP Enabled Site

The most basic onboarding for the CloudBlade can be done in two simple steps:
The following steps differ from the previous 1.x version of the CloudBlade. However, the previous method of tagging sites and interfaces will still work to maintain backward compatibility and facilitate migrations.
  • Configure Circuit Categories
  • Configure Site Tags
  • Configure circuit categories.
    1. Navigate to
      Manage
      Resources
      Circuit Categories
    2. From the list of
      Circuit Categories
      displayed, select the ellipsis for the category that you would like to modify.
    3. Under
      TAGS
      , apply the
      prisma_region:<region>:<SPN>
      tag to enable the circuit category for Prisma Access.
    4. Once applied, the circuit category will reflect that it is enabled/tagged for Prisma Access.
    5. Repeat this set of steps to enable Prisma Access on the appropriate circuits.
  • Configure site tag(s).
    1. Locate a site to onboard to Prisma Access by navigating to
      Manage
      Sites
      .
    2. Select a site to modify and on the
      Configuration
      screen, click the
      Edit
      icon.
    3. On the
      Edit Site
      screen, select or type
      prisma_access
      in the
      Tags
      field.
      Once this configuration is completed, on the next integration run, the CloudBlade will begin the onboarding process to connect the Prisma SD-WAN ION device and Prisma Access. This process takes place through one or more IPSec tunnels, depending on how many interfaces and tags are configured. Note that it may take several integration cycles for all the tunnels to appear and be active on the Prisma SD-WAN portal.

Recommended For You