: Assign IPsec Tunnels to your Site
Focus
Focus

Assign IPsec Tunnels to your Site

Table of Contents

Assign IPsec Tunnels to your Site

To assign IPsec tunnels to your site:
  1. Click the MAP tab.
  2. Locate your device on the map, and then click it.
  3. Click the device to edit its settings.
  4. Navigate to Interface Config.
  5. Add the first IPsec tunnel.
  6. Click the + icon near the ports, select Standard VPN, and click Add. The Tunnel Configuration page will open.
  7. Name should be an alias for this tunnel. In this case, we will name it to Check Point Tunnel 1.
  8. Admin Up should be a.
  9. Parent Interface should be set to the outbound interface.
  10. Inner Tunnel IP / Address Mask should be set to an internal IP behind your device that you should allocate for the tunnel.
  11. Endpoint should be set to the Endpoint that represented a tunnel defined in the previous step. In our case, this should be set to .
  12. Peer Hostname should be set to the destination of the first Check Point tunnel that you copied from the previous steps.
  13. Peer IP should remain empty.
  14. IPSec Profile should be set to the IPsec Profile that we defined at the first step.
  15. Click Create Standard VPN. An indication at the top-right corner should appear in case the tunnel was created successfully or not.
  16. Click Cancel to go back to the interface configuration.
  17. Repeat this process for the second IPsec tunnel.
    After creating the second IPsec tunnel, once again, an indication at the top-right corner should appear in case the tunnel was created successfully or not.
  18. Click Cancel to go back to the interface configuration.