If you receive an error message during the bootstrapping process, refer to the following table for details.
Error message (Severity)
Boot image error (high)
No bootstrap config file on external device (high)
The external device did not have the bootstrap configuration file.
Bad or no parameters for mandatory networking information in the bootstrap config file (high)
The networking parameters required for bootstrapping were either incorrect or missing. The error message lists the value—IP address, netmask, default gateway—that caused the bootstrap failure.
Failed to install license key for file <license-key-filename> (high)
The license key could not be applied. This error indicates that the license key used was invalid. The output includes the name of the license key that could not be applied.
Failed to install license key using authcode <authcode> (high)
The license auth code could not be applied. This error indicates that the license auth code used was invalid. The output includes the name of the authcode that could not be applied.
Failed content update commits (high)
The content updates were not successfully applied.
USB media prepared successfully using given bundle (informational)
The bootstrap image has been successfully complied on the USB flash device. <username>: Successfully prepared the USB using bundle <bundlename>
Successful bootstrap (informational)
The firewall was successfully provisioned with the bootstrap configuration file. The output includes the license keys installed and the filename of the bootstrap configuration. On the VM-Series firewalls only, the PAN-OS version and content update version are also displayed.
Recommended For You
Recommended videos not found.