: Install the Slide Rail into the Rack
Focus
Focus

Install the Slide Rail into the Rack

Table of Contents

Install the Slide Rail into the Rack

Install the slide rail into a standard 19 inch rack using the given components of the Prisma SD-WAN ION 7000 device.
Install the slide rail into a standard 19 inch rack as described below:
  1. Select a 1-U slot to insert the slide rail into a standard 19-inch rack.
  2. Snap the three (3) square pegs of the rail into the front and back mounting plate of the rack.
  3. Ensure that you fully engage the spring retention clip so that the rail is securely attached to the mounting plate.
    If the rack has square holes:
    1. Insert the slide rails into a standard 19-inch rack making sure that the rails snap into place.
    2. Attach the chassis-mounting brackets to either side of the ION 7000.
    3. Slide the ION 7000 into the rack and confirm that the device is installed securely in the rack.
    If the rack has threaded round holes:
    1. Unscrew and detach the square rail snap ends from both ends of each rail.
    2. Using screws that fit the threads of the rack (not included), attach each end of the rail to the rack.
    3. Attach the chassis-mounting brackets to either side of the ION 7000.
    4. Slide the ION 7000 into the rack and confirm that the device is installed securely in the rack.
    If the rack has unthreaded round holes:
    1. Insert the rail as sent behind the hole plate.
    2. Using screws that fit the threads of the rail (not included), screw through the hole in the plate to the screw holes on the end of the rack (from the front).
    3. Attach the chassis-mounting brackets to either side of the ION 7000.
    4. Slide the ION 7000 into the rack and confirm that the device is installed securely in the rack.

Recommended For You