: Set up IoT Security and XSOAR for Qualys Integration
Focus
Focus

Set up IoT Security and XSOAR for Qualys Integration

Table of Contents

Set up
IoT Security
and XSOAR for Qualys Integration

Set up
IoT Security
and
Cortex XSOAR
to integrate with Qualys.
  1. Log in to
    IoT Security
    and from there access Qualys settings in
    Cortex XSOAR
    .
    1. Log in to
      IoT Security
      and then click
      Integrations
      .
    2. IoT Security
      uses
      Cortex XSOAR
      to integrate with Qualys, and the settings you must configure to integrate with it are in the XSOAR interface. To access these settings, click
      Launch
      Cortex XSOAR
      .
      The
      Cortex XSOAR
      interface opens in a new browser window.
    3. If necessary, search for
      qualys
      to locate it among other instances.
  2. Edit the settings for PANW IoT 3rd Party Qualys Integration Instance.
    1. Click the active integration instance settings icon ( ) to open the settings panel.
    2. Enter the following and leave other settings at their default values:
      Qualys API server URL
      : Enter the URL of the Qualys API server.
      Credentials
      : Enter the username of the Qualys API manager user account you previously created.
      Password
      : Enter the password associated with user account.
      Run on Single engine
      : Choose
      No engine
      .
      Do not change the default integration instance name. The preconfigured XSOAR jobs that support vulnerability scans from the Device Details page in the
      IoT Security
      portal rely on XSOAR playbooks that refer to this integration instance name specifically.
    3. When finished, click
      Run test
      or
      Test
      .
      If the test is successful, a Success message appears. If not, check that the settings were entered correctly and then test the configuration again.
    4. After the test succeeds, click
      Save & exit
      to save your changes and close the settings panel.
  3. To enable PANW IoT 3rd Party Qualys Integration Instance, click
    Enable
    .
  4. Run the PANW IoT Get Qualys Scanners and Profiles job.
  5. Return to the
    IoT Security
    portal and check the status of the Qualys integration instance.
    XSOAR automatically runs a preconfigured job for Qualys integration and reports the integration instance to
    IoT Security
    , which displays it on the Integrations page. The integration instance can be in one of the following four states as shown in the Status column on the Integrations page:
    • Disabled
      means that either the integration was configured but intentionally disabled or it was never configured and a job that references it is enabled and running.
    • Error
      means that the integration was configured and enabled but is not functioning properly, possibly due to a configuration error or network condition.
    • Inactive
      means that the integration was configured and enabled but no job has run for at least the past 60 minutes.
    • Active
      means that the integration was configured and enabled and is functioning properly.
    When you see that the status of the Qualys instance has changed from
    Disabled
    to
    Active
    , its setup is complete.
    For more information about Qualys vulnerability scans, see Get Vulnerability Scan Reports from Qualys.

Recommended For You