Set up Cisco WLAN Controllers for Integration
Table of Contents
Set up Cisco WLAN Controllers for Integration
Set up Cisco WLAN controllers for integration with
IoT Security
through Cortex XSOAR
.When an XSOAR engine connects to a Cisco WLAN controller,
it must authenticate itself by presenting a valid username and password belonging
to a user account with read/write privileges. It can either use
an existing user account or one that you can create specifically
for it.
The following instructions are based on Cisco
controller software release 8.5.131.0.
- Create a user with read/write privileges.
- Log in to the UI for one of the WLAN controllers and click .
- On the page, enter the following and then clickApply:User Name: Enter the name for the user account.PasswordandConfirm Password: Enter a password for the user account.Usernames and passwords are case-sensitive and can contain up to 24 ASCII characters. They cannot contain spaces and they cannot have characters repeated more than three times consecutively.User Access Mode:ReadWrite
- To save your changes, clickSave Configuration.
- Repeat the above steps to create user accounts on other controllers to which XSOAR engines must connect.