Prisma Access
Panorama
Table of Contents
Expand All
|
Collapse All
Prisma Access Docs
-
- Prisma Access China
- 4.0 & Later
- 3.2 Preferred and Innovation
- 3.1 Preferred and Innovation
- 3.0 Preferred and Innovation
- 2.2 Preferred
-
-
-
- 5.0 Preferred and Innovation
- 4.2 Preferred
- 4.1 Preferred
- 4.0 Preferred
- 3.2 Preferred and Innovation
- 3.1 Preferred and Innovation
- 3.0 Preferred and Innovation
- 2.2 Preferred
Panorama
Panorama
Learn how to configure a ZTNA Connector in
Prisma Access (Managed by Panorama)
.Use the following workflow to enable ZTNA Connector in
Prisma Access (Managed by Panorama)
.- Configure the IP address blocks thatPrisma Accesswill use internally to route traffic to the ZTNA Connector and the private apps you onboard.
- Selectand Edit thePanoramaCloud ServicesConfigurationService SetupSettings.
- On theZTNA ConnectortabAddanApplication IP Block.You can add a single Application IP Block, or multiple blocks depending on your deployment. For example, if 100.64.10.0/24 and 100.64.11.0/24. You can alsoEnable Advertise Application IP Block to Remote Networks.Use RFC 1918 or RFC 6598 addresses. You can specify an RFC 1918 address pool during ZTNA Connector setup instead of RFC 6598; however, you cannot change the address pool type back to RFC 6598 after you specify RFC 1918.
- Set theConnector IP BlocksthatPrisma Accesswill use internally to route traffic between mobile users, remote networks and the connector VMs in your data centers.You can add a single Connector IP Block, or multiple blocks depending on your deployment. For example, enter 100.65.10.0/24 and 100.65.11.0/24.
- ClickOKto save the IP address block configuration and thenCommitand push the configuration.
- Launch ZTNA Connector from the Cloud Services Plugin on Panorama.
- Select.PanoramaCloud ServicesZTNA Connector
- Click theto launch ZTNA Connector in thePrisma AccessAppPrisma Accessapp on the hub.
- From thePrisma Accessapp, select.SettingsZTNA Connector
- If you haven't already done so,Enable ZTNA Connector.
- Prisma Accessbegins setting up the infrastructure for the ZTNA Connector. This may take a few minutes.
- When onboarding finishes, the ZTNA Connector Overview displays.