Prisma SD-WAN
Configure Dynamic Routing
Table of Contents
Configure Dynamic Routing
In Prisma SD-WAN, you can configure dynamic routing using BGP for a branch or data
center. The configuration on a branch ION device is identical to a data center ION
device.
| Where Can I Use This? | What Do I Need? |
|---|---|
|
|
You can configure dynamic routing using Border Gateway Protocol (BGP) for a branch or data
center. The configuration on a branch ION device is identical to a data center ION
device with the exception of prefix advertisement in a branch and additional core
and edge peers in a data center.
Configure dynamic Border Gateway Protocol (BGP) routing on a branch ION device for
Internet, private WAN underlays, LAN and standard VPNs. The ION device learns routes
dynamically from private WAN and standard VPN BGP peers and distributes to the LAN
BGP peers. Routes learnt from LAN peers will be sent to the Prisma SD-WAN controller
via API and to other LAN and private WAN BGP peers.
On a DC mode ION, you can configure dynamic routing only on those
interfaces of the ION device, which are configured as—Peer with a
Network or a standard VPN interface. ION devices in data centers do
not support routing on interfaces configured as Use to Connect to
Internet.
The differences in configuration between a branch ION device
and a data center ION device in the relevant sections.
Use
the following steps to configure dynamic routing using BGP: