config syncd
Use the config syncd command to enable or disable the syncd
service on the branch device.
Enable: When you enter this command, the service starts immediately and is configured to
start automatically after each system reboot.
Disable: When you enter this command, the service stops immediately and remains disabled
even after a system reboot.
Because standalone branch devices don't have a High Availability (HA) peer to synchronize
with, you only need the syncd service for branch HA deployments where
two devices operate as an active-standby pair.
Command
config syncd (enable | disable)
Options
| enable | Enter the config syncd enable, the service starts
immediately and is configured to start automatically after each
system reboot. |
| disable | Enter the config syncd disable, the service stops
immediately and remains disabled after a system reboot. |
Command Notes
| Role | Super, Read Only, Monitor |
|
| Introduced in | Release 6.6.1 |
Example
config syncd disable
Syncd disabled.
config syncd enable
Syncd enabled.
