: Configure Internet Ports
Focus
Focus

Configure Internet Ports

Table of Contents

Configure Internet Ports

Let us learn to configure internet ports.
  1. From internet ports, select a port pair.
  2. To enable the interface, for
    Admin Up
    , select
    Yes
    .
  3. (Optional)
    Enter a description.
  4. For
    Interface Type
    , select
    Port
    .
  5. For
    Use these Ports For
    , select
    Internet
    .
    Alternatively, you can select
    Private WAN
    for
    Use these Ports For
    to configure a WAN port for a Private WAN circuit.
  6. For
    Scope
    , toggle
    Local
    or
    Global
    .
    The default is
    Local
    .
    If the scope is local, the route is not advertised to the data center.
    If the scope is global, the route is advertised to the data center.
    • This setting is applicable only to branch sites. It is not applicable to data center sites.
    • Configuring a global static route will advertise the destination IP/prefix to other sites automatically.
  7. For
    Circuit Label
    , select the circuit label that corresponds to your internet connection for this site.
  8. Select
    Enable IPv6 On This Interface
    to configure IPv6.
  9. For
    IPv6 Configuration
    , select
    AutoConf
    or
    Static
    .
    Autoconf
    indicates the Global IP address is derived using stateless address autoconfiguration (SLAAC).
    Choose
    Static
    if the IP address is fixed and is manually assigned. Additionally specify the
    IPv6 Address/Mask
    ,
    Default Gateway (IPv6)
    , and
    DNS server(s)(IPv6)
    .
  10. For
    IPv4 Configuration
    , select
    DHCP
    or
    Static
    .
    Choose
    DHCP
    if the IP address is dynamically assigned.
    Choose
    Static
    if the IP address is fixed and is manually assigned. Additionally specify the
    IP Address/Mask
    ,
    Default Gateway
    , and
    DNS server(s)
    .
  11. In Advanced Options,
    (optional)
    specify
    MAC
    ,
    IP MTU
    ,
    External NAT Address and Port (IPv4)
    ,
    External NAT Address and Port (IPv6)
    ,and
    Physical
    from the available range.
    IP MTU value should be at least 1280 for IPv6. If it is less than 1280, IPv6 cannot be enabled.
  12. Click
    Save Port
    .
    The ION device inherently hardens all the ports designated as
    Internet
    . You can access only UDP 4500, 500 (ISAKMP), and ESP ports. The utilization of UDP port 500 (ISAKMP) is exclusively reserved for standard VPNs. Configure the ports accordingly to avoid automatic rejection of requests. The ION device blocks any unsolicited incoming internet traffic.

Recommended For You