Redistribution profiles direct the firewall to filter, set priority,
and perform actions based on desired network behavior. Route redistribution
allows static routes and routes that are acquired by other protocols
to be advertised through specified routing protocols.
Redistribution profiles must be applied to routing protocols
in order to take effect. Without redistribution rules, each protocol
runs separately and does not communicate outside its purview. Redistribution
profiles can be added or modified after all routing protocols are
configured and the resulting network topology is established.
Apply redistribution profiles to the RIP and OSPF protocols by
defining export rules. Apply redistribution profiles to BGP in the Redistribution
Rules tab. Refer to the following table.
Redistribution Profile
Settings
Description
Name
Add a Redistribution
Profile and enter the profile name.
Priority
Enter a priority (range is 1-255) for this
profile. Profiles are matched in order (lowest number first).
Redistribute
Choose whether to perform route redistribution
based on the settings in this window.
Redist—Select
to redistribute matching candidate routes. If you select this option,
enter a new metric value. A lower metric value means a more preferred
route.
No Redist—Select to not redistribute
matching candidate routes.
General Filter Tab
Type
Select the route types of the candidate
route.
Interface
Select the interfaces to specify the forwarding
interfaces of the candidate route.
Destination
To specify the destination of the candidate
route, enter the destination IP address or subnet (format x.x.x.x
or x.x.x.x/n) and click Add. To remove an
entry, click remove (
).
Next Hop
To specify the gateway of the candidate
route, enter the IP address or subnet (format x.x.x.x or x.x.x.x/n)
that represents the next hop and click Add.
To remove an entry, click remove (
).
OSPF Filter Tab
Path Type
Select the route types of the candidate
OSPF route.
Area
Specify the area identifier for the candidate
OSPF route. Enter the OSPF area ID (format
x.x.x.x), and click Add.
To remove
an entry, click remove (
).
Tag
Specify OSPF tag values. Enter a numeric
tag value (1-255), and click Add.
To remove an entry, click
remove (
).
BGP Filter Tab
Community
Specify a community for BGP routing policy.
Extended Community
Specify an extended community for BGP routing
policy.