You can use a tap interface to monitor traffic on a port.
To configure a tap interface, click the name of an Interface
(ethernet1/1, for example) that is not configured and specify the
following information.
Tap Interface Settings
Configured In
Description
Interface Name
Ethernet Interface
The interface name is predefined and you
cannot change it.
Comment
Enter an optional description for the interface.
Interface Type
Select Tap.
Netflow Profile
If you want to export unidirectional IP
traffic that traverses an ingress interface to a NetFlow server,
select the server profile or click Netflow Profile to
define a new profile (see Device > Server Profiles > NetFlow). Select None to
remove the current NetFlow server assignment from the interface.
Virtual System
Ethernet InterfaceConfig
If the firewall supports multiple virtual
systems and that capability is enabled, select a virtual system
for the interface or click Virtual System to define
a new vsys.
Security Zone
Select a security zone for the interface
or click Zone to define a new zone. Select None to
remove the current zone assignment from the interface.
Link Speed
Ethernet InterfaceAdvancedLink Settings
Select the interface speed in Mbps, or select auto to
have the firewall automatically determine the speed.
Link Duplex
Select whether the interface transmission
mode is full-duplex (full), half-duplex (half),
or negotiated automatically (auto).
Link State
Select whether the interface
status is enabled (up), disabled (down),
or determined automatically (auto).
PoE Rsvd Pwr
Ethernet InterfaceAdvancedPoE Settings
(Supported firewalls only)
Select the amount of allocated
power in Watts if PoE is enabled.
PoE Enable
Select to enable PoE on this interface.
When using Panorama, non-PoE
interfaces display the option to enable or disable PoE. To avoid a
commit failure, ensure that PoE Enable
remains selected on these non-PoE interfaces.