Enter a name for the profile (maximum of 31 characters). The name must start with an alphanumeric character, underscore (_), or hyphen (-), and contain zero or more alphanumeric characters, underscore (_) or hyphen(-). No dot (.) or space is allowed.

Enter the number of seconds between PIM Assert messages that the logical router sends to other PIM routers on the multiaccess network when they are electing a PIM forwarder. Range is 1 to 65,534; default is 177.

Enter the number of seconds between PIM Hello messages that the logical router sends to its PIM neighbors from each interface in the interface group. Range is 1 to 180; default is 30.

Enter the number of seconds between PIM Join messages (and between PIM Prune messages) that the logical router sends upstream toward a multicast source. Range is 60 to 600; default is 60.

Enter a name for the profile (maximum of 31 characters). The name must start with an alphanumeric character, underscore (_), or hyphen (-), and contain zero or more alphanumeric characters, underscore (_) or hyphen(-). No dot (.) or space is allowed.

Enter the maximum number of seconds allowed for a receiver to respond to an IGMP membership Query message before the logical router determines that the receiver no longer wants to receive multicast packets for the group. Range is 1 to 25; default is 10.

Enter the number of seconds between IGMP membership Query messages that the logical router sends to a receiver to determine whether the receiver still wants to receive the multicast packets for a group. Range is 1 to 1,800; default is 125.

Enter the number of seconds allowed for a receiver to respond to a Group-Specific Query that the logical router sends after a receiver sends a Leave Group message. Range is 1 to 25; default is 1.

If you enable this, when there is only one member in a multicast group and the logical router receives an IGMP Leave message for that group, this setting causes the logical router to remove that group and outgoing interface from the multicast routing information base (mRIB) and multicast forwarding information base (mFIB) immediately, rather than waiting for the Last Member Query Interval to expire. Enabling this setting saves network resources. Default is disabled.

Add an MSDP Authentication profile by name (maximum of 63 characters). The name must start with an alphanumeric character, underscore (_), or hyphen (-), and can contain a combination of alphanumeric characters, underscore, or hyphen. No dot (.) or space is allowed.

Enter the Secret (alphanumeric characters, !, @, #, %, and ^ are allowed). Confirm Secret.

Add an MSDP Timer profile by name (maximum of 63 characters). The name must start with an alphanumeric character, underscore (_), or hyphen (-), and can contain a combination of alphanumeric characters, underscore, or hyphen. No dot (.) or space is allowed.

Enter a value in seconds; range is 1 to 60; default is 60. After an MSDP transport connection is established with a peer, each side of the connection sends Keepalive messages to the other side at this interval to keep the MSDP session active. If the timer expires, the peer sends a Keepalive message and resets the timer. If no Keepalive or SA message is received for the Message Timeout interval, the MSDP session is reset.

Enter a value in seconds, which is the interval at which the MSDP peer will wait for Keepalive messages from other peers before declaring them down. Range is 1 to 75; default is 75.