End-of-Life (EoL)

Configure IKEv2 Traffic Selectors

In IKEv2, you can configure Traffic Selectors, which are components of network traffic that are used during IKE negotiation. Traffic selectors are used during the CHILD_SA (tunnel creation) Phase 2 to set up the tunnel and to determine what traffic is allowed through the tunnel. The two IKE gateway peers must negotiate and agree on their traffic selectors; otherwise, one side narrows its address range to reach agreement. One IKE connection can have multiple tunnels; for example, you can assign different tunnels to each department to isolate their traffic. Separation of traffic also allows features such as QoS to be implemented. Use the following workflow to configure traffic selectors.
  1. Select
    Network
    IPSec Tunnels
    Proxy IDs
    .
  2. Select the
    IPv4
    or
    IPv6
    tab.
  3. Click
    Add
    and enter the
    Name
    in the
    Proxy ID
    field.
  4. In the
    Local
    field, enter the
    Source IP Address
    .
  5. In the
    Remote
    field, enter the
    Destination IP Address
    .
  6. In the
    Protocol
    field, select the transport protocol (
    TCP
    or
    UDP
    ) from the drop-down.
  7. Click
    OK
    .

Recommended For You