End-of-Life (EoL)

Configure a Static Route

Perform the following task to configure Static Routes or a default route for a virtual router on the firewall.
  1. Configure a static route.
    1. Select
      Virtual Router
      and select the virtual router you are configuring, such as
    2. Select the
      Static Routes
    3. Select
      , depending on the type of static route you want to configure.
    4. Add
      for the route.
    5. For
      , enter the route and netmask (for example, for an IPv4 address or 2001:db8:123:1::1/64 for an IPv6 address). If you’re creating a default route, enter the default route ( for an IPv4 address or ::/0 for an IPv6 address).
    6. (
      ) For
      , specify the outgoing interface for packets to use to go to the next hop. Use this for stricter control over which interface the firewall uses rather than the interface in the route table for the next hop of this route.
    7. For
      Next Hop
      , select one of the following:
      • IP Address
        —Enter the IP address (for example, or 2001:db8:49e:1::1) when you want to route to a specific next hop. You must
        Enable IPv6 on the interface
        (when you Configure Layer 3 Interfaces) to use an IPv6 next hop address. If you’re creating a default route, for
        Next Hop
        you must select
        IP Address
        and enter the IP address for your Internet gateway (for example, or 2001:db8:49e:1::1).
      • Next VR
        —Select this option and then select a virtual router if you want to route internally to a different virtual router on the firewall.
      • Discard
        —Select to drop packets that are addressed to this destination.
      • None
        —Select if there is no next hop for the route. For example, a point-to-point connection needs no next hop because there is only one way for packets to go.
    8. Enter an
      Admin Distance
      for the route to override the default administrative distance set for static routes for this virtual router (range is 10-240; default is 10).
    9. Enter a
      for the route (range is 1-65,535).
  2. Choose where to install the route.
    Select the
    Route Table
    (the RIB) into which you want the firewall to install the static route:
    • Unicast
      —Install the route in the unicast route table. Choose this option if you want the route used only for unicast traffic.
    • Multicast
      —Install the route in the multicast route table (available for IPv4 routes only). Choose this option if you want the route used only for multicast traffic.
    • Both
      —Install the route in the unicast and multicast route tables (available for IPv4 routes only). Choose this option if you want either unicast or multicast traffic to use the route.
    • No Install
      —Do not install the route in either route table.
  3. (
    ) If your firewall model supports BFD, you can apply a
    BFD Profile
    to the static route so that if the static route fails, the firewall removes the route from the RIB and FIB and uses an alternative route. Default is
  4. Click
  5. Commit the configuration.

Recommended For You