GlobalProtect Gateways General Tab

Select NetworkGlobalProtectGatewaysGeneral to define the gateway interface to which the agents or apps can connect and specify how the gateway authenticates endpoint clients.
GlobalProtect Gateway General Settings
Enter a name for the gateway (up to 31 characters). The name is case-sensitive and must be unique. Use only letters, numbers, spaces, hyphens, and underscores.
For a firewall that is in multiple virtual system mode, the Location is the virtual system (vsys) where the GlobalProtect gateway is available. For a firewall that is not in multi-vsys mode, the Location field does not appear in the GlobalProtect Gateway dialog.
After you save the gateway configuration, you cannot change the Location.
Network Settings Area
Select the name of the firewall interface that will serve as the ingress interface for remote endpoints. (These interfaces must already exist.)
IP Address
(Optional) Specify the IP address for gateway access. Select the IP Address Type, then enter the IP Address.
  • The IP address type can be IPv4 (IPv4 traffic only), IPv6 (IPv6 traffic only), or IPv4 and IPv6. Use IPv4 and IPv6 if your network supports dual-stack configurations, where IPv4 and IPv6 run at the same time.
The IP address must be compatible with the IP address type. For example, for IPv4 or 21DA:D3:0:2F3b for IPv6. If you choose IPv4 and IPv6, enter the appropriate address type for each.

Related Documentation