The following table explains the block list entry for a source
IP address that the firewall is blocking.
Month/day and hours:minutes:seconds when
the IP address went on the Block IP List.
Type of block action: whether the hardware
(hw) or software (sw) blocked the IP address.
When you configure
a DoS Protection policy or a Security policy that uses a Vulnerability
Protection profile to block connections from source IPv4 addresses,
the firewall automatically blocks that traffic in hardware before
those packets use CPU or packet buffer resources. If attack traffic
exceeds the blocking capacity of the hardware, the firewall uses
software to block the traffic.
Source IP Address
Source IP address of the packet that the
Security zone assigned to the interface
where the packet entered the firewall.
Number of seconds remaining for the IP address
to be on the Block IP List.
Name of the classified DoS Protection profile
or Vulnerability protection object name where you specified the
Block IP action.
Total Blocked IPs: x out of y (z% used)
Count of blocked IP addresses (x) out of
the number of blocked IP addresses the firewall supports (y), and
the corresponding percentage of blocked IP addresses used (z).