: Resolve Zero Log Storage for a Collector Group
Focus
Focus

Resolve Zero Log Storage for a Collector Group

Table of Contents

Resolve Zero Log Storage for a Collector Group

The log storage capacity for the Collector Group might display as 0MB if the disk pairs are not enabled for logging in the Log Collectors. To enable the disk pairs, perform the following steps for each Log Collector in the Collector Group.
  1. Add the RAID disk pairs.
    1. Select
      Panorama
      Managed Collectors
      and click the Collector Name.
    2. Select
      Disks
      ,
      Add
      each RAID disk pair, and click
      OK
      .
  2. Commit the changes to Panorama and push the changes to the Collector Group.
    1. Select
      Commit
      Commit and Push
      and
      Edit Selections
      in the Push Scope.
    2. Select
      Collector Groups
      , select the Collector Group you modified, and click
      OK
      .
    3. Commit and Push
      your changes.
  3.  Verify the state of the Log Collectors and disk pairs.
    1. Select
      Panorama
      Managed Collectors
      and verify that the configuration of each Log Collector is synchronized with Panorama.
      The Configuration Status column should display
      In Sync
      and the Run Time Status column should display
      connected
      .
    2. Click
      Statistics
      in the last column for each Log Collector and verify that the disk pairs are
      Enabled
      and
      Available
      .

Recommended For You