Onboard a Non-ECMP Site
Table of Contents
Onboard a Non-ECMP Site
316 PIC
Once the CloudBlade is configured, you can integrate Prisma SD-WAN and Palo Alto Prisma Access
for Networks.
The
following steps differ from the previous 1.x version of the CloudBlade.
However, the previous method of tagging sites and interfaces will
still work to maintain backward compatibility and facilitate migrations.
The
most basic onboarding for the CloudBlade can be done in two simple steps:
- Configure circuit categories.
- Navigate to
- From the list of Circuit Categories displayed,
select the ellipsis for the category that you would like to modify.
![]()
- Under TAGS, apply the prisma_region:<region>:<SPN> tag
to enable the circuit category for Prisma Access.
![]()
- Once applied, the circuit category will reflect that
it is enabled/tagged for Prisma Access.
![]()
- Repeat this set of steps to enable Prisma Access on the appropriate circuits.
- Configure
site tag(s).
- Locate a site to onboard to Prisma Access by navigating to or .
- Select a site to modify and on the site summary screen,
click the Edit icon.
![]()
- On the Edit Site screen, select
or type prisma_access in the Tags field.
![]()
Once this configuration is completed, on the next integration run, the CloudBlade will begin the onboarding process to connect the Prisma SD-WAN ION device and Prisma Access. This process takes place through one or more IPSec tunnels, depending on how many interfaces and tags are configured. Note that it may take several integration cycles for all the tunnels to appear and be active on the Prisma SD-WAN portal.
