Configure a Static ARP
Table of Contents
Configure a Static ARP
Prisma SD-WAN allows to configure static ARP.Layer 3 LAN interface to
include the static address resolution protocol (ARP).
| Where Can I Use This? | What Do I Need? |
|---|---|
|
|
Prisma SD-WAN extends the capabilities of
the Layer 3 LAN interface to include the static address resolution protocol
(ARP). Configure a static ARP on the branch site devices
on 5.5.1 and later versions. If you have static ARP configured on
any LAN interface, downgrading to a lower version is not allowed.
- Select , select the device you want to configure.On the Basic Info screen, toggle Yes for Enable L3 Direct Private WAN Forwarding and Enable L3 LAN Forwarding then Save.Select the Interfaces tab.Select a port that connects to the LAN.Select Yes for Admin Up.(Optional) Enter a Description and add Tags.Select Port or BypassPair as the Interface type.For Use This Port For, select LAN.Toggle Scope as either Global or Local.Select IPv4 Configuration as either DHCP or Static.(Optional) In Advanced Options, specify MAC, IP MTU, Physical from the available range or the drop-down, and Static ARP Config.The IP addresses and MAC addresses mapping for static ARP can have a maximum of 16 entries per Layer 3 LAN interface.The MAC addresses should be provided in the shown xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx format.Interface type must be physical, or sub-interface, or bypass pair for configuring static ARP.When static ARP is configured on the LAN interface, you cannot disable LAN forwarding.
![]()
Save Port.
