>
    debug bw-test src-interface
    Focus
    Download PDF
    Focus
    1. Home
    2. Prisma
    3. Prisma SD-WAN
    4. Use CLI Commands
    5. Debug Commands
    6. debug bw-test src-interface
    Download PDF

    debug bw-test src-interface

    Table of Contents

    debug bw-test src-interface

    Use the debug bw-test src-interface command to run a single bandwidth capacity test of a circuit. Information displayed includes link capacities in Mbps, percentage loss in bandwidth, and jitter.

    Command

    debug bw-test src-interface <interface> <destination=>

    Options

    interfaceEnter the source interface.
    destinationEnter the destination URL. The destination URL is pcm.cgnx.net for Internet circuits. For private WAN circuits, use pcm.cgnx.net or the data center ION device's IP address.

    Command Notes

    RoleSuper
    Related Commands—
    Introduced inRelease 4.6.1

    Example

    debug bw-test src-interface controller1 destination=pcm.cgnx.net
				Press CTR+C to stop.
				Units of downlink and uplink capacity measurement are Mbps.
				capacity_uplink 31.782000read entry not available. go with default
				Final Downlink capacity estimate: 9.14
				-------------------------------------------------
				Downlink percentage loss: 19.20
				Downlink Jitter: 2.99 ms
				-----------------------------------------
				Final Uplink capacity estimate: 31.78
				-------------------------------------------------
				Uplink rtt: 330.01 ms
				Uplink Percentage Loss: 2.90
				Uplink Jitter: 3.44 ms

    © 2024 Palo Alto Networks, Inc. All rights reserved.