Enable, Pause, Disable, and Uninstall the Integration
Expand all | Collapse all
Enable, Pause, Disable, and Uninstall the Integration
After the integration is set up, operations
can be done using the CloudBlade panel. These operations have various
effects on the tunnels and configurations in Prisma SD-WAN and Prisma
Access for Networks (Cloud Managed) CloudBlade.
- Set the CloudBlade to Enabled
This is the standard,
expected mode of operation for the CloudBlade. The CloudBlade will
run, find any new Sites/Interfaces with the appropriate tags, and configure
the integration on Prisma Access for Networks.
- Set the CloudBlade to Paused
Pausing the CloudBlade
stops all future integration runs, but leaves any created objects
intact. This stops any future objects from getting created, and
also prevents removal of any unconfigured/untagged objects.
- Set the CloudBlade to Disabled
Disabling the CloudBlade
tells the system to remove and delete all configurations created
by the CloudBlade. This can cause communication interruptions if policy
is not set to use other paths. The IPsec policies, IKE policies,
and Prisma SD-WAN Endpoints and Service and DC groups are not automatically
deleted and must be removed manually.
- Uninstall the CloudBlade
Uninstalling the CloudBlade
removes the configuration for the CloudBlade, and immediately stops
any changes by the CloudBlade. Uninstalling the CloudBlade does not
automatically remove configuration from all sites and objects. CloudBlades
may be uninstalled and reinstalled to facilitate upgrades or downgrades
to different versions without traffic interruption. To completely
remove all items, set the CloudBlade to Disabled for 2-3 Integration
Run periods before uninstalling the CloudBlade.
