Manage the GCP-NCC Integration CloudBlade
Manage the GCP-NCP cloudblade.
After the integration is set up, you
can choose to change the Admin State of the CloudBlade to the following
scenarios from the CloudBlade configuration page.
Set the CloudBlade to Enabled
This is
the default mode of operation for the CloudBlade. The CloudBlade
will run, find any new resources, and configure the integration
on GCP-NCC related resources.
Set the CloudBlade to Paused
Pausing the
CloudBlade stops all future integration runs but leaves any created
GCP-NCC resources intact. This stops any future resources from getting
created. When paused the CloudBlade will not deploy or delete the
resources nor will it stop the user from deleting any resources.
Changes will be tracked by the CloudBlade and reverted once enabled.
Set the CloudBlade to Disabled
Disabling
the CloudBlade tells the system to remove and delete all GCP-NCC
resources created by the CloudBlade.
Set the CloudBlade to Uninstalled
Uninstalling
the CloudBlade removes the resources for the CloudBlade, and immediately
stops any changes by the CloudBlade. To completely remove all items,
set the CloudBlade to disabled for 2-3 Integration Run periods before
uninstalling. The GCP-NCC CloudBlade must always be disabled before
uninstalling, else, if you wish to reinstall in the same region,
it may not create the resources. Also, check the Status
Monitor tab in the Prisma SD-WAN web interface, if all
resources are empty/deleted before uninstalling.
