set deviceconfig system eth3
Focus
Focus
Advanced WildFire

set deviceconfig system eth3

Table of Contents

set deviceconfig system eth3

Description

Configure the eth3 interface.

Hierarchy Location

set deviceconfig system

Syntax

eth3 { default-gateway <ip-address>; ip-address <ip-address>; mtu <value>; netmask <ip-netmask>; speed-duplex {100Mbps-full-duplex | 100Mbps-half-duplex | 10Mbps-full-duplex | 10Mbps-half-duplex | 1Gbps-full-duplex | 1Gbps-half-duplex | auto-negotiate}; permitted-ip <ip-address/netmask>; service disable-icmp {no | yes}; }

Options

+ default-gateway
— IP address of the default gateway for the eth3 interface.
+ ip-address
— IP address for the eth3 interface.
+ mtu
— Maximum Transmission Unit (MTU) for the eth3 interface.
+ netmask
— Netmask for the eth3 interface.
+ speed-duplex
— Interface speed (10Mbps, 100Mbps, 1Gbps, or autonegotiate) and duplex mode (full or half) for the eth3 interface.
> permitted-ip
— IP addresses allowed to access the eth3 interface. If you specify a netmask with the IP address, the netmask must be in slash notation. For example, to specify a Class C address, enter: 10.10.10.100/24 (not 10.10.10.100 255.255.255.0).
> service-disable
— Disable ICMP for the eth3 interface.

Sample Output

admin@wf-500(active-controller)# show deviceconfig system eth3 eth3 { ip-address 10.10.20.120; netmask 255.255.255.0; service { disable-icmp no; } speed-duplex auto-negotiate; mtu 1500; }

Required Privilege Level

superuser, deviceadmin

Recommended For You