Prisma Access for Networks Non-Aggregate Bandwidth Licensing
Table of Contents
Prisma Access for Networks Non-Aggregate Bandwidth Licensing
Prisma Access
for Networks Non-Aggregate Bandwidth Licensing4.0.0 PIC
Configure the
Prisma Access
CloudBlade in the non-aggregate bandwidth
licensing mode, where the bandwidth is allocated for the remote network through the
CloudBlade integration. Non-Aggregate to Aggregate Bandwidth Migration
In
Prisma Access
, the aggregate bandwidth model is available for all new deployments.
If you have an existing deployment that allocates bandwidth by location
(non-aggregate bandwidth model), you can migrate from allocating bandwidth per
location to allocating bandwidth per compute location (aggregate bandwidth model).
This migration feature is enabled from Prisma Access
release version 2.2.0-H30
and 2.2.0-H35
onwards.You can verify the completion of the non-aggregate to aggregate migration tasks in
the Panorama system logs.
When the Non-Aggregate Bandwidth to Aggregate Bandwidth migration is complete on
Panorama, the
Prisma SD-WAN
interface tags are updated to the Aggregate Bandwidth
form, and the following changes are done by the Panorama Integration Container (PIC)
on the SD-WAN controller:
The CloudBlade won’t allow any new changes made to the sites
until the above process is complete. It will display the following message
Non Aggregate to Aggregate Bandwidth Migration is in
progress
in the CloudBlade Messages
tab.- If a circuit tag exists, the circuit tag is updated with the SPN Name: if an interface tag exists, the interface tag is updated with the corresponding SPN Name for the remote network.
- If a circuit tag exists and no interface tagging exists: Circuit Tag is updated with the SPN Name and the Interface tag will be updated if the corresponding remote network ends on a different SPN Name than the circuit tagged SPN Name.
This capability isn’t supported for remote networks if you use the Aggregate
Bandwidth mode.
QoS for Non-Aggregate Bandwidth
The QoS parameters for non-aggregate bandwidth
mode in
Prisma Access
CloudBlade can be configured as part of the interface tagging
in the Panorama Integration Container (PIC). Following is the format in which the
interface tag is specified.Format: prisma_qos:<QoSProfileName>
Example: PRISMA_QOS: test_profile
This capability isn’t supported for remote networks if you use the Aggregate
Bandwidth mode.