Palo Alto Networks firewalls can inspect SCTP traffic
in roaming and radio access network (RAN) security use cases.
When deploying a Palo Alto Networks
to inspect SCTP traffic in a mobile network, you must determine
the connection points or 3GPP interfaces in the network that you
want the firewall to secure. SCTP is used across various evolved
packet core (EPC) signaling interfaces, such as N2, S1-MME, S6a/S6d,
S13/S13’ and S9.You can Configure
SCTP Security on supported Palo Alto Networks firewall models
by creating an SCTP Protection profile, which you attach to a Security
policy rule for a zone; the SCTP Protection profile enforces the
SCTP security capabilities.
A mobile network operator’s most common use cases for SCTP security
are roaming security and radio access network (RAN) security. GTP Deployments also include roaming
security and RAN security. The best practice is for you to configure
both GTP and SCTP security when you have a roaming or a RAN security
As a best practice, deploy the firewalls in a high availability
(HA) active/passive configuration; SCTP security is not supported
in an HA active/active configuration.
In this roaming security use case, the firewall inspects SCTP
traffic that is exchanged between home and visitor networks, as
shown in the following figure. (A legend of acronyms follows the
In the case of the firewall located between the HSS and
MME (orange dashed connection), the protocol in use is Diameter-3GPP-S6a
The blue dashed connection uses Diameter-3GPP-S13 over SCTP
between the MME and EIR network nodes. An EIR database contains
lists of IMEI numbers associated with handsets.
The green dashed connection is from the Home PCRF through
the firewall to the Visited PCRF and it uses Diameter S9 over SCTP.
In each roaming association, a mobile network operator communicates
with its roaming partners over a GSMA, GRX, or IPX network.
In the RAN security use case, the firewall inspects SCTP traffic
that is exchanged over S1-MME and S6a interfaces, as shown in the
The orange dashed connection represents an SCTP association over
an S1-MME interface between eNodeB and MME, and SCTP transports
S1AP. The blue dashed connection represents an SCTP association
over an S6a interface between MME and HSS, and SCTP transports the
Diameter S6a application.
The green dashed connection represents an SCTP association over
an N2 interface between 5G RAN and AMF, and SCTP transports NG Application
Acronyms in the Topology Figures
Access and Mobility Management Function
Mobile Management Entity
Policy and Charging Rules Function
Equipment Identity Register
Packet Data Network
Evolved Packet Core
General Packet Radio Service
Public Land Mobile Network
GPRS Roaming Exchange
Radio Access Network
Global System for Mobile Communications Association