Claim the Prisma SD-WAN ION and Assign to a Datacenter
Table of Contents
Claim the Prisma SD-WAN ION and Assign to a Datacenter
Learn how to claim the ION device and assign it to a data center site.
After the ION successfully boots, as long
as it can connect to the Prisma SD-WAN controller it will show up
as Unclaimed: Online under the Map -> Unclaimed Devices section
of the portal.
It can take up to 10 minutes for the
ION to show up in the Controller.
- Claim the device by selecting .It will transition to an offline state while going through the claiming process.
- Create a Data Center Site while the
device is being claimed.
- Select .
- Enter a name for the site and other site details and click Next.
- Add an Internet Circuit in the Circuits section
and click Next.
![]()
- Assign the device to the data center by selecting Assign
Devices and selecting the ION device from the list of
Select Devices and
Save.
![]()
- Once the device is successfully assigned, click the device name to enter the
device configuration screen.
- Enter a Device Name.
![]()
- Configure Port 1, by assigning the Internet WAN circuit label you
created in step 2 and providing the external NAT address and
port.To figure out the external IP address go to
the Azure portal and find the Public IP address provisioned in the
resource group.
![]()
![]()
- Configure port 2 to be Admin Up and Use this port to: Peer with a
Network, and set for DHCP.
![]()
- Enter a Device Name.
- Configure a static default route pointing to the gateway
of port 2 (the 1st IP address of the private subnet specified in
the deployment template).
![]()
![]()
- Switch the site to Control mode and verify the VPNs are
up and active.
![]()
Proceed to the next section to finalize the Azure deployment steps.
