Known Issues in Panorama Plugin for Cisco ACI 1.0.1
The following list describes known issues
in the Panorama plugin for Cisco ACI 1.0.1.
The Panorama plugin for Cisco ACI stops monitoring if
it requests more memory than Panorama allocates to plugins. If you
do not allocate enough memory to your Panorama, you might encounter
Log in to the Panorama CLI and execute the
request plugins reset-plugin only plugin plugin-name cisco
This command restarts the plugin and releases the memory used by
the plugin. To avoid this issue in the future, increase the memory
of your Panorama. Allocate additional memory to
your Panorama virtual appliance to avoid this issue in the future.
The Panorama plugin for Cisco ACI requires Panorama
8.1.6 or later. However, you can install the plugin on older versions
of Panorama 8.1.x. When installed on 8.1.0 to 8.1.5, the plugin
cannot be configured.
Upgrade Panorama to 8.1.6 or later.
The plugin does not immediately process new monitoring
definitions after you configure and commit them under
the monitoring definition must complete the configured monitoring interval
before it begins processing the new monitoring definition. For example,
if the monitoring interval is set to 10 minutes, the monitoring
definition status will update after 10 minutes.
Synchronize Dynamic Objects
Panorama to sync with the APIC before the monitoring interval expires.