You have a computer with network access to Panorama.
You know the Panorama IP address.
The Management interface supports SSH, which is the default
setting. If an administrator disabled SSH and you want to re-enable
it: select
Panorama
Setup
Interfaces
, click
Management
,
select
SSH
, click
OK
,
select
Commit
Commit to Panorama
, and
Commit
your
changes to the Panorama configuration.
To access the CLI using SSH:
Enter the Panorama IP address
in the SSH client and use port 22.
Enter your administrative access credentials when prompted.
After you log in, the message of the day displays,
followed by the CLI prompt in Operational mode. For example:
admin@ABC_Sydney>
Use a serial port connection to log in to the Panorama
CLI.
Make sure that you have the following:
A null-modem serial cable that connects Panorama
to a computer with a DB-9 serial port
A terminal emulation program running on the computer
Use the following settings in the terminal emulation
software to connect: 9600 baud; 8 data bits; 1 stop bit; No parity;
No hardware flow control.
Enter your administrative access credentials when
prompted. After you log in, the message of the day displays, followed
by the CLI prompt in Operational mode.
Change to Configuration mode.
To switch to Configuration mode, enter the following command
at the prompt: