>
    Configure an Interface as a DHCP Relay Agent
    Focus
    Download PDF
    Focus
    1. Home
    2. PAN-OS
    3. DHCP
    4. Configure an Interface as a DHCP Relay Agent
    Download PDF

    Configure an Interface as a DHCP Relay Agent

    Table of Contents

    Configure an Interface as a DHCP Relay Agent

    To enable a firewall interface to transmit DHCP messages between clients and servers, you must configure the firewall as a DHCP relay agent. The interface can forward messages to a maximum of eight external IPv4 DHCP servers and eight external IPv6 DHCP servers. A client DHCPDISCOVER message is sent to all configured servers, and the DHCPOFFER message of the first server that responds is relayed back to the requesting client.
    Capacities are as follows:
    • You can configure a combined total of 500 DHCP servers (IPv4) and DHCP relay agents (IPv4 and IPv6) on all firewall models except for PA-5200 Series and PA-7000 Series firewalls
    • On PA-5220 firewalls, you can configure a maximum of 500 DHCP servers and a maximum of 2,048 DHCP relay agents minus the number of DHCP servers configured. For example, if you configure 500 DHCP servers, you can configure 1,548 DHCP relay agents.
    • On PA-5250, PA-5260, and PA-7000 Series firewalls, you can configure a maximum of 500 DHCP servers, and a maximum of 4,096 DHCP relay agents minus the number of DHCP servers configured. For example, if you configure 500 DHCP servers, you can configure 3,596 DHCP relay agents.
    Before configuring a DHCP relay agent, make sure you have configured a Layer 3 Ethernet or Layer 3 VLAN interface, and the interface is assigned to a virtual router and a zone.
    1. Select DHCP Relay.
      Select
      Network
      DHCP
      DHCP Relay
      .
    2. Specify the IP address of each DHCP server with which the DHCP relay agent will communicate.
      1. In the
        Interface
         field, select the interface you want to be the DHCP relay agent.
      2. Select either
        IPv4
         or
        IPv6
        , indicating the type of DHCP server address you will specify.
      3. If you checked
        IPv4
        , in the
        DHCP Server IP Address
         field,
        Add
         the address of the DHCP server to and from which you will relay DHCP messages.
      4. If you checked
        IPv6
        , in the
        DHCP Server IPv6 Address
         field,
        Add
         the address of the DHCP server to and from which you will relay DHCP messages. If you specify a multicast address, also specify an outgoing
        Interface
        .
      5. (
        Optional
        ) Repeat the prior three steps to enter a maximum of eight DHCP server addresses per IP address family.
    3. Commit the configuration.
      Click
      OK
       and
      Commit
      .

    Recommended For You

    © 2024 Palo Alto Networks, Inc. All rights reserved.