PAN-OS 10.2.8-h10 Addressed Issues

Fixed an issue where the firewall web interface was blank after logging in.

(VM-Series firewalls in HA configurations only) Fixed an issue where BGP routes from the active firewall were lost when the passive firewall was rebooted.

(PA-3400 Series firewalls only) Fixed an issue where the firewall entered maintenance mode after enabling kernel data collection during the silent reboot.

Fixed an issue where the firewall stopped responding when processing traffic.

Fixed an issue on Panorama where, when the Commit and Push button was clicked during a selective Commit and Push operation, the window stopped responding, which caused the operation to be delayed.

Fixed an issue fixed where a process unexpectedly stopped due to a memory mapping in an incorrect location.

Fixed an issue where the useridd process logs were flooded with an error message related to service profiles.

Fixed an issue where selective push operations did not work when more than one admin user simultaneously performed changes and partial commits on Panorama.

Fixed an issue on firewalls in HA configurations where packets were dropped over HA3 HSCI due to the default MRU being incorrect.

Fixed an issue where device telemetry failed after upgrading due to bundle generation failure.

Fixed an issue where multiple all_task processes stopped responding, which caused the dataplane to fail.

(VM-Series firewalls on Microsoft Azure environments only) Fixed an issue where CPU usage was higher than expected after a hotplug event when Accelerated Networking was enabled for the management interface.

Fixed an issue on the Panorama web interface where no content was displayed after logging in.

Fixed an issue where the snmpd process stopped responding.

Fixed an issue on the firewall where the dataplane went down due to a path monitor failure caused by an out-of-memory (OOM) condition related to the pan_task process.

Fixed an issue where a Push to Device operation remained at the state None when performing a selective push to device groups and templates that included both connected and disconnected firewalls.

(PA-3400, PA-5400, and PA-1400 Series firewalls only) Fixed an issue where virtual wire ports did not go down when moving from an active state to a suspended state.

Fixed an issue where changes committed on Panorama were not reflected on the firewall after a successful push.

Fixed an issue related to continuous interface flapping.

Fixed an issue where selective push operations failed with the following error message SelPush:Base config is invalid! invalid configuration. Schema verification failed. This occurred when a policy rule was moved from the post-rule base to the pre-rule base.

Fixed an issue where the using QoS caused packet buffer utilization to increase exponentially and the PKI POOL DFLT pool depleted until a reboot was performed.

Fixed an issue where rib-out routes were not displayed due to the next hop of BGP local routes not getting matched with export filters.

(VM-Series firewalls in Microsoft Azure environments only) Fixed a Dataplane Development Kit (DPDK) issue where interfaces remained in a link-down stage after an Azure hot plug event.

Fixed an issue where ARP entries were unable to be completed for subinterfaces with SNAT configured.

Fixed an issue where Authentication Portal redirects failed with a 500 Internal error when the Authentication Portal token was disabled.

Fixed an issue where heartbeats to the brdagent process were lost and the process stopped responding, which caused the firewall to reboot.

Fixed an issue where Security policy rules did not display values for FQDN.

Fixed an issue where template configurations were not properly pushed to the firewall during an export or push of the device configuration bundle.

Fixed an issue on Panorama where Commit and Push or Push to Devices operations failed when an external dynamic list was configured to check for updates every 5 minutes due to the commit and external dynamic fetch processes overlapping.