Focus

PAN-OS Web Interface Help

Route Redistribution

Table of Contents

Route Redistribution

Network > Virtual Router > Redistribution Profiles

Redistribution profiles direct the firewall to filter, set priority, and perform actions based on desired network behavior. Route redistribution allows static routes and routes that are acquired by other protocols to be advertised through specified routing protocols.

Redistribution profiles must be applied to routing protocols in order to take effect. Without redistribution rules, each protocol runs separately and does not communicate outside its purview. Redistribution profiles can be added or modified after all routing protocols are configured and the resulting network topology is established.

Apply redistribution profiles to the RIP and OSPF protocols by defining export rules. Apply redistribution profiles to BGP in the Redistribution Rules tab. Refer to the following table.

Redistribution Profile Settings	Description
Name	Add a Redistribution Profile and enter the profile name.
Priority	Enter a priority (range is 1-255) for this profile. Profiles are matched in order (lowest number first).
Redistribute	Choose whether to perform route redistribution based on the settings in this window. Redist—Select to redistribute matching candidate routes. If you select this option, enter a new metric value. A lower metric value means a more preferred route. No Redist—Select to not redistribute matching candidate routes.
General Filter Tab
Type	Select the route types of the candidate route.
Interface	Select the interfaces to specify the forwarding interfaces of the candidate route.
Destination	To specify the destination of the candidate route, enter the destination IP address or subnet (format x.x.x.x or x.x.x.x/n) and click Add. To remove an entry, click remove ( ).
Next Hop	To specify the gateway of the candidate route, enter the IP address or subnet (format x.x.x.x or x.x.x.x/n) that represents the next hop and click Add. To remove an entry, click remove ( ).
OSPF Filter Tab
Path Type	Select the route types of the candidate OSPF route.
Area	Specify the area identifier for the candidate OSPF route. Enter the OSPF area ID (format x.x.x.x), and click Add. To remove an entry, click remove ( ).
Tag	Specify OSPF tag values. Enter a numeric tag value (1-255), and click Add. To remove an entry, click remove ( ).
BGP Filter Tab
Community	Specify a community for BGP routing policy.
Extended Community	Specify an extended community for BGP routing policy.

Static Routes

RIP